Home » Posts tagged 'Painted Texture 3D EF'

Tag Archives: Painted Texture 3D EF

September Swaps and Mystery Card #16-Origami Frame Card

Hello Stamping Friends,

It is almost over- September – and summer – and ….. boo hoo

. NO it is “Woo hoo” – that means fall is here, with its pumpkins and scarecrows and pumpkin spice lattes and …..

.  And only 86 days until Christmas!  Just sayin……

We will be ready!!

Mystery Card Challenge #16 printable pdf file

It is an Origami Frame Card (also called Shadow Box Technique, Folded Paper Frame, and Origami Window Frame)!

This is the one I created with the specific instructions.  I used the wintry 3D embossing folder and since it is made for the mini machine, I just rotated the folder 180 degrees so there were no half embossed images and ran it a second time.  I used the Baby Wipe Technique for the greeting from the Frosted Gingerbread stamp set by placing a baby wipe on our largest acrylic block and then drip dropping red and green ink from the reinkers on the baby wipe to create my own mixed color ink ‘pad’.  The base is Cinnamon Cider and the DSP is Gingerbread & Peppermint DSP from the mini catalog.

  • The 4X4 DSP is folded lightly in half and then opened up and folded lightly in half again to find the middle point, or use a pencil and a ruler to draw diagonal lines from each corner to corner to find the middle, then erase the pencil mark.
  • Unfold and fold each corner with its point exactly in the center.   Burnish well with your bone folder (1st folds)
  • Fold back the corner points to about 1/8″ over the 1st folds and burnish well.
  • Place at least two glue dots underneath the frame folds at the very edge of the 1st fold, you want the folds to pop a little at the second fold but be held in place at the first fold.  Glue dots were less visible than when I used the mini dimensionals.

There are several different ways to place the frame on your card. In the card above, I used the 3X3 square offset from the frame to make added points to the frame but in this card I placed the 3X3 exactly under the frame for just a border:

I used an extra layer of Old Olive since I was using DSP from the Gingerbread & Peppermint DSP which was a bit busy.

  • Old Olive Layer, 4 1/8 X 5 3/8
  • DSP Layer, 4 X 5 1/4
  • Basic White for stamping the greeting,  2 3/4 X 2 3/4 (I had fun with all the dies in the Gingerbread Dies!)

This next card uses the 3X3 for a border again instead of extra points since the back of the DSP that folds out is the same blue and got lost when I looked at having the extra points with blue on blue.  This uses the Back On Your Feet stamp set.

Differences from the original:

  • Beauty of The Earth DSP,  4 X 5 1/4
  • Cinnamon Cider, 3 3/4  X  5, embossed with Painted Texture 3D embossing folder
  • Basic White for stamping the greeting,  2 3/4 X 2 3/4

The Origami Frame would also fit on a card with a horizontal alignment.

Sharon used the 3X3 for extra points and made a stunning card with the Sale A Bration Peaceful Prints DSP, Cherry Cobbler and Basic Black:

 

Joy’s card uses the Hand Penned DSP and Gorgeous Grape with the Timeworn Type 3D Embossing Folder:

 

Ann made two cards in differing colors and two different embossing folders- the Ornate Floral 3D on the left and the Timber 3D on the right:

 

Thank you for participating in the Mystery Card Challenge and sharing your cards!

We Zoom on the 4th Tuesday of each month at 9:30 to share our swaps and do a Mystery Card Challenge.  Hop on by some time, just send your email address to me at [email protected].

  Don’t go until you share those swap cards!

Oh dear, I almost did. This was my swap and if you click on the picture you can go to the blog post with all the directions and even a video:

  


Sharon’s card celebrates the beauty of fall with gorgeous die cut leaves on fall DSP and she used the Autumn Wheelbarrow Dies from last year’s holiday mini, Pierced Blooms Dies, Seasonal Layers Dies, and Autumn Wishes from Close To My Heart.

 


Jo’s Card uses Stampin’ Up! Reflected In Nature stamps on Thick Basic White with a full panel of brown embossed with the Wood Grain embossing folder.  The shiny strip is Stampin’ Up! Rose Specialty Paper:


I wish you could see the sparkle on Joy’s card.  She used the Triple Time Stamping Technique with the Stampin’ Up! Daisy Garden and Vine Design stamp sets with a border between her layers of Blackberry Beauty DSP.   The little dragonfly is punched in black and then sparkled with the gold!


 Ann’s card is a fun Halloween card using Pumpkin Pie and Basic Black.  She sponged the edge of the Pumpkin Pie with black for a smoky look.  She used Stampin’ Up!’s Frightfully Cute stamp set, the Scalloped Contour Dies, the Frightful Tag Dies, the Cute Halloween DSP, and Black Glitter Paper.  The star sequins and black and white gingham ribbon are the perfect embellishment!


  Your blog is like a virtual scrapbook of cards!

So true!  And for you travelers and out of staters who missed the Mystery card, you can still make one and send me the picture and I can add it to the ‘virtual scrapbook’.  I think it really helps everyone see the amazing things we can do with a bit of paper, stamps, tools and ink.  An added benefit of our card scrapbook is to go back and see a card that we may have already mailed out but now want to make one like it.  Well, here is your place to go to see those past cards.  My cards are in the recipe box because they are linked to the full directions but you can always do a search by “swaps” and find the others.

And the ‘scrapbook’  brings a pinch of creativity to spice up their crafting worlds!  

Mustn’t forget to say that, Sal, so they see where you come in!

SAL,   Share A Love

Karen (Click on little Sal in the computer to go to the online store)

 

 

 

 

 

 

 

 

 

Welcome to my blog!

Sal Window to Products

Subscribe to Blog via Email

Enter your email address to subscribe to this blog and receive notifications of new posts by email.

Join 158 other subscribers

Categories